can you create a phase checker please? living on the DX bus, or as an auduisuite plugin? thing is this: I align thousands of clips on a movie project. after some audiosuite processings, lavs can get out of phase a little bit again, but you wont really notice, until you just align again, and see the phase changing (and hearing it sounds a bit tighter again). standard phase checkers like insight or ozone imager always show dead center, even you nudge the clips by a frame or so. so basically, standard phase checkers show the same result before and after alignment always. i would wish for a quick and easy way to check my whole session for alignment errors before handing over to the mix.